Failure to heed this warning couldД¬ause severe personal injury and/or property This area must be kept clear of people and When closing awning, bottomДЄrm will fold down and against back channel. When there is no longer the need to shed water it will return Loaded left arm will automatically lower the height of theДЄwning approximately 9 inches to allow water to run off. If water builds up on the awning, the spring Your A & E awning is designed to shed water if left out Important: As an extra safety precaution, visually You leave the awning unattended the awning Periods of heavy rain, or wind is expected or Press and hold the вЂњRetractвЂќ button for 3 seconds and the awningДurable and can be operated during light rain If the sensor isДЄctivated or the retract button is depressed and theДЄwning rolls up, damage to the awning and attachedДЎ. Important: Do not attach or hang any objects from This condition occurs, the bottom 2 wind speed LEDвЂ™s will Note: Awning is not intended for cold weather operation.ДЄwning will automatically close when outside temperature Occur in high winds if the awning is left in the open position To de-activate the wind sensor feature, simultaneouslyДepress and hold buttons 3 & 4 on the Remote Control Mounted in a storage compartment), simultaneously depress and hold buttons 1 & 2 on the Remote Control (KeyДЇOB) for 3 seconds. The wind sensor feature, locate the control box (usually When wind conditions are present that may damage theДЄwning. Sensing device that will automatically close the awning

The A & E WeatherPro awning is equipped with a wind This however, will not prevent the awning from вЂњextensionвЂќ mode is de-activated and awning will notД®xtend. When the ignition key is turned вЂњONвЂќ, the вЂњextensionвЂќ when vehicle ignition key is in the вЂњONвЂќ RV, this system is wired to prevent accidental awning The wind speed selection button until the desired To increase or decrease the sensor sensitivity, press and release The wind speed can be adjusted by pressing the Wind speed is preset from the factory at 18Дў. The LED that is yellow indicates the wind speedДЎ. Indicates a communication fault between the windДЎ. When the LED is flashing Yellow and alternatesДЇlashing with the selected wind speed LED, this Time per second, this indicates that the voltage isД«elow 10 (В±. When the LED is flashing Yellow at the rate of 1 That there is 12 VDC power at the control.Дў. 12 VDC Power Indicator/Fault IndicatorДЎ When the LED is constant Yellow this indicates Important: When installed correctly on a motorizedДЄ. There are six (6) LEDвЂ™s in the WeatherPro control and one The control box will automatically restore Wait approximately 30 seconds before depressing button again. Important: When the power has been interrupted, The sensing probe can be cleaned with a mild soap

KeepДЄirway clear of dust, insects, ice, snow, or other debris. Rectly if the airway to the sensing probe is clear. Important: The wind sensor will only function cor. The wind sensor is specifically designed to allow air to pass If wind sensor is de-activated and damage to awning occurs, the awning warranty will be void. Obstructions in the proximity of the wind sensor can diminish the sensitivity. Three seconds the awning will remain in the position when button is To de-activate the wind sensor simultaneously press and hold buttons 3 & 4 To activate the wind sensor, simultaneously press and hold buttons 1 & 2 for

Dometic weatherpro power awning manual